This was something of a unexpected bug found in our code dealing with a mapping variable and i was unable to figure out why was the variable value not taken up as expected.

The issue was when i was trying to pass a value from a port to the Variable and use the same in the Workflow. So while i was checking at the Session level, the value was different whereas the same Port value flowing to the target was looking correct.

With some repeated run and test, i was able to catch what had really went wrong. Here i used a mapping variable defined and i had my only option to set the Aggregation option as either ‘MAX’ or ‘MIN’. So went on to select ‘MAX’.

Then comes assigning the port value to the variable with SETVARIABLE(). In doing so i was assuming the value on every run shall just be assigned to the Variable here. I was completely wrong with this assumption.

As referred in the Informatica content-Help,

 “At the end of a successful session, the PowerCenter Integration Service compares the final current value of the variable to the start value of the variable. Based on the aggregate type of the variable, it saves a final current value to the repository. Unless overridden, it uses the saved value as the initial value of the variable for the next session run.”

Breaking this down for an easy understanding – The Variable $$Var will first be assigned the default value, then on the successful run when we try setting a new value say here default value was $$Var=10 and i am having a new value as ’15’ and my aggregation was type ‘MAX’ and so compares the new value with old and finds the new is greater value so $$Var=15 is assigned.

And now this value $$Var shall not change or be over written until i get a value >15. So was my issue where the new values were not assigned as expected with SETVARIABLE().

Thus my solution was to set a minimum value before the session starts, as simple as it is to just make it a override value through Parameter file (.prm file) and so i set it as ‘$$Var=0’. Now my new value gets always the greater value and is assigned to the variable with the latest 🙂

Hope this makes a good understanding, please put down your questions and comments if any. Thanks!!

%d bloggers like this: